When you have installed the Toit firmware on your ESP32, the following two default configurations have been set:
The default value of 'Max offline' for the device is 0 seconds, which means that the device is continuously awake.
The default firmware version on the device is the one installed during initial provisioning.
How to change the device configurations is explained below. Changes are applied once the device comes online. Some changes needs a device reboot.
To change the device configurations, navigate to the Configuration tab for the given device and edit the configuration as described below.
The current firmware version installed on the device is displayed in the Firmware section. Click on the Edit icon and choose a new version from the drop down menu, then click Save. The proposed change is displayed both in the Firmware section and with an icon near the name of the device until the new version is actually installed the next time the device comes online.
By default, the device is configured to be continuously online (with 'Max offline' set to zero seconds). If your device operates on battery in production, it is recommended to change this configuration so that the device is online only when necessary to extend battery life.
In the Configuration tab for a given device, go to the 'Max offline' section and change the value (using hours, minutes and seconds) before clicking Save. The parameter will be changed next time the device comes online.
If you install an application measuring the temperature every hour and the
max-offline parameter is set to 24 hours, the application will run the program every hour and the ESP32 will go to deep sleep between runs.
Every 24 hours after application deployment, the device will go online, connect to the Toit console, and offload all the data to the console, as well as check for updated configuration and firmware updates.
A device can come online due to other triggers than
max-offline, for example when its storage capacity level reaches a predefined threshold, as explained in the section below.
When the device has been online the first time after initial provisioning, you can change or add new connections on the device.
Navigate to the Configuration tab, Connections section for the given device. Click on the Edit button to open the pop-up window in which you can add or delete a connection.
When two or more connections are present, choose the order in which they should be used by moving the connections to use in priority above the others.
Note that changes to connections will not take effect until the device is rebooted.
Your device will attempt to come online based on the
Max offline parameter.
When the device is offline, the data (such as logs, system metrics, and data generated by the apps running on the device) is stored on the device.
Reaching the full capacity of storage defined for this type of data means that the latest data will not be stored correctly.
To avoid this situation, it is possible to filter which type of logs and system metrics are saved on the device.
In addition, a threshold of storage is set to trigger an online connection where data can be flushed from the device to the console.
You can remove a device from your Toit project using the Unclaim button.